ok what i suggest to you to do is take the box off the cable fully then do a new factory default on it then switch it off at the back switch then turn it back on then connect it to the cable again when you are scanning make sure there is nothing else on the cable also top box provider >>> n** or Cho*** next box under that leave that set at>>>>>>> NETWORK and only press the green button then NOTHING ELSE let me know how you get on
Okay fergusrb, I tried all that and its still the same. It skips the step where you select the Network ID (N** Dub Legacy) so it runs with the default TPs which returns no channels. I reckon I will send it back. Thanks again fergus. Any further ideas would be appreciated.
I would like to know what the kryptview manufacturer,s view on this box would be.Would they consider it as been tampered with?[Due to firmware been installed]I wish you well mate.
i dont think there will be a problem with it if the box is faulty just send them a mail and tell them what your problem is and should not be a problem
Guys, i got the stuff on the A**0 but when i try to manually scan using the frequencies given earlier.....everything comes back FAILED. I'M doing the MMDS bit......Help
[/quote] i dont think there will be a problem with it if the box is faulty just send them a mail and tell them what your problem is and should not be a problem[/quote] I just emailed them the details . Will keep you informed. Gotta go now.
i had same prob yesterday cudnt find tps only the 7 that were on the kv,so first i did a manual search on a lower frequency then when i got a few channels then i did an automatic scan then it picked up the lot
what box is it and if you are referring to numbers forget about it take the freq from your old box and add them to your arnet and you cannot put them into boxes in ireland any more
fergus received the kyptview thaks alot..... listen i just want to know what i have to do first so i dont mess up anything,? please... all knew to me sorry........
all the stuff is on the end of my post download the tutorial and the video first read and look at it then download the loader and the software make sure when you are getting the download ready to load you turn the box off at the back hit download then put the switch back on
Fergus, Quick stupid question. I'm on N*L Dublin and have had my A750 up and running for over a week now, all with your help so thanks. The question is should I have the PAL/NTSC setting on PAL or NTSC? I've tried both and honestly can't see that much of a difference!! One other thing. Is there a recommended "best settings list" for the optional system settings etc? Cheers, Ben
Did the codes just roll in Dublin on Nagra 2? I got a message on my Kryptview for a minute saying "awaiting code update"
Lads just got my kryptview and downloaded software. Question is when connecting it tothe telly does the n*l input cable go into the Rf in on the back of the box.
yes it goes into the top connector on the box and scart lead from box to the tv then if you go back a bit you will see the connector you need if you did not get one with the box
thanks to you all for the earlier posts. i was told that if you put the same codes in the super box it would give back the channels. obviously someone talking bulls**t
Just trying to download software onto my kryptview but keep getting an error message 'The downloading is not requested' Any ideas what Im doing wrong. Thanks