have used the links from eamos lib for the downloads so think there right and the cable is one that we had that worked with the starview, it has screw on conections on both ends one conected to back of pc and other end to the kyrptview and its grey in colour, am i a lost cause ??
im sure somebody here will be able to help but im all out of ideas.i only done my own one today.try downloading the stuff from eamos again.make sure its the march 09 firmware
No if it worked before it should work again,is this the bin file you downloaded? http://www.4shared.com/file/93874977/70b87202/Kryptview_19032009.html you could try and redownload it.
yes thats the download alright, i think its something on my pc as its now saying the downloading is not requsted.
yes thats a good sign,now i'm not making you out to be stupid or anything but have you the batteries in your remote so as you can use it for the flash as per instructions from eamo's?
dont worry i wont take offence,i'm glad of any suggestions and would love at this stage for it to be something as simple as the batteries but alas no i have them in and i double press the red button then the stand by as per instructions and the box goes from displaying 0000 to dot running across the bottem then to on and back to oooo and displayed on the pc is downloading is not requested or file size zero depending on which port i'm on, i've been trying them all.
try doing as i said and halpinio said and delete the file and redownload,by the way where are you based?
Can i just suggest that you start the download with the box powered off and then turn the box on. Is this the procedure you are following: (courtesy of Fergus!) Ok here is the correct procedure for putting the firmware on to the Arnet and should only be done this way and no other no matter what you have read else where DO NOT HAVE YOUR BOX PLUGGED IN FOR THIS WHEN YOU ARE SETTING YOUR DOWNLOAD UP FIRST MAKE SURE YOU HAVE SET THE LOADER TO THE CORRECT COM PORT 1 get your loader double click it another box will appear 2 click on download another box will appear 3 click on browse and find the firmware and tell it to open 4 click on download then plug in the Arnet and wait for it to download 5 you will see on the front of the box display it going aroung in a square 6 then when it is finished you will see it going faster wait till the box reboots itself before you stop anything and then you can disconnect all the cables 7 DO NOT PRESS RED RED AS THIS IS NOT TO BE USED UNDER ANY CIRCUMSTANCES AS ALL THIS DOES IS CONFUSE THE BOX 8 then do a factory reset then go to auto put your provider in leave the network alone 9 press the green button if you are on N** you will get only 2 options after it has gone thru the process you select legecy not upc ok then press ok and it will scan away for the freq you need to be patient as this will take a bit of time
will give that a go and in the morning and let you know how i get on, thanks to everyone for the help but have to sign off now as have been at this since 2pm today and need a break from it so till 2moro thanks again.
similar story , have new kryptview dublin. cant load eamos latest bin file. the stb editor says a download was not requested, even though the tv says its waiting on a code update. i did an autoscan and had basic stations.and had had settled on port three. i did with this with the box on and and off.but both times it refused to down load the bin file. i am using a usb port to a p232 connection as my laptop only has a usb connection. so i just cant down anything into the devise and i had this trouble with my old box also. i am beginning to wonder shoud i check the cable.
Just followed instructions in SG8's last post.I was having similar problems getting firmware loaded. Worked a treat,all channels working perfectly. Thanks a mil.
