sg8 that was sorted for us thanks and to everyone that helped me yesterday thanks very much dont know what i would do without you guys am all sorted now with the flashing and to anyone else thats havin probs if you keep getting a file not requested warning just turn box off at the back and try againg and keep doing this and it will work eventually, all i need now is a RF connector as its a screw on conection so hopefully thats it, thanks again
no luck yet .The stp editor keeps saying " the down loading is not requested" when i have the box on and reading 0000 i have a go. when i have the box off i have a go. i have switched the box off half a dozen times and the back on. still the same. any ideas. i followed the insructions as near as i could, no messing with remote
THANKS MOOLY THATS WHERE THE 0000 ON THE LCD ARRIVE INTO THE MELTING POT. 0000 WONT BE DISPLAYED UNLESS THE FACTORY RESET HAS BEEN DONE.IT will be a station number instead(THATS WHAT IWAS DOING RONG YESTERDAY. But TODAY, INSTEAD OF PRESSING DOWNLOAD I PRESSED START AND THEN 3 HITS ON THE REMOTE,RED RED AND STANDBY AND LO AND BEEEEEEHOLD ZOOOOOM IT ALL WENT IN. THANKS AGAIN.
hi i got a kyrptview de other day but havin trouble flashin it, i hav a 9 pin to 9 pin female null modem cable ,but this doesn't fit into port in pc ,would a 9 pin to usb adaptor work??? Also if i hav no joy flashin it myself is there any1 in dublin tht could flash it 4 me, will bring it wherever and will pay to get this done thks
hi not sure about usb workin but i feel like i've been to hell and back over last few days getting my kyrptview up and running and couldnt have done it without the help of great guys on afterdawn so maybe have a read back over some of the posts in this thread and see if any of its any use to you, best of luck
hi squeeky. the answer is it does work i had to get an adaptor in peats for 20 euro. got a penny change. (32 euro in maplins) my lap top only has a usb. i presume you can bring the cable that can connect to your box to the shop.you will get a cable with a usb on one end and a nine pin plug on the other that fits into the cable you have.
I used a usb adaptor and followed SG8's instructions and it worked fine.You just need to make sure you select the correct usb port from your pc in the code sending window of the loader.
thks everybody for ur help got my kyrptview up and running ,special thks 2 dub12dave helped me out alot thks again m8.
