limerick ch***s

I'm setting up a st*rview in limerick.New to this.Can anybody give me step by step instructions to get me up & working.regards

 

forgot to mention,i'm on ch***s.

 

Depends on if you have Chor*s True Cable or MMDS (Aerial on roof)

 

i'm on ch*r*s cable.

 

You will have to do a manual scan on all the frequencies below

Menu > Installation > Manual Scan

Down Freq ( Enter Freq here )
Symbol Rate 6875

Here are the latest frequencies for Ch**** True Cable: It is area dependent so not 100% , these are for Dublin.


274.000 371.000
282.000 378.000
290.000 394.000
298.000 410.000
306.000 427.000
314.000 444.000
322.000

 

Many Thanks Celtic71,
Not to sure about the frequencies.I've tried an auto scan but didn't pick up any channels even though the ordinary signal is crystal clear.
Regards 8miles0.

 

You will need to manual scan freq for Chor*s

 

Celtic71,
will try again.
regards 8miles0.

 

Celtic71,
Not sure if this is a daft question.I assume there is a frequency for each channel.Does that mean with the 13 frequencies you get only 13 channels ?.
regards 8miles0.

 

There are numerous channels per freq ,

e.g. (These are for N*L on 339.500)
Rte 1 339.5
Rte 2 339.5
Tv 3 339.5
Tg 4 339.5
Living 339.5
E4 339.5
History 339.5
Bravo 339.5
Biography 339.5
Paramount comedy 2 339.5

 

Celtic71,
Thanks.
regards 8miles0.

 

i've tried a st*rv**w box on ch***s.Received channels ok.Put in correct keys for ch***s,saved it but unable to unscramble chans.When I go back in to keys,it shows the keys for n*l.I'm using software version 400.any ideas ?.

 

Press Menu then 1570 and check the EMU key is ON

 

Another thing , check if you have a clone or genuine and I tell you if you have the right firmware installed

Count the vents on top

18x7 = Clone
25x7 = Genuine

Also you can go here to see some pics
http://www.freewebs.com/dooby2oon

 

genuine box & emu switched on.
thanks 8miles0

 

Are you sorted now ?

V4 is correct for genuine b0xes

 

chans still scrambled,genuine box,put in correct codes for ch***s,saved,emu on,exit.update percentage keeps going up,doesn't stop.
regards 8miles0

 

Press Menu 1570 go into Nagravision and tell me what it says for key data 00 and 01

 

for Ch***s provider id 5E 01
key 00 A9 86 6E EA 39 EA 09 49
key 01 B8 4A BD 38 4B 27 47 A2

The problem appears to be: set ch***s keys saved them,but when I go back into nagravision the n*l keys are shown.

 

Try these keys and make sure you press OK after entering 00 data and then go up to 01 and enter keys and press OK again to save


KEY 00 = 4B 7C D5 86 E7 01 CC 96

KEY 01 = 8E 8E 46 FD 36 28 A3 F0