Moved to Here http://forums.afterdawn.com/thread_view.cfm/531363

whats your provider?

 

make sure to turn the emu back on after rescanning

 

cal7 255 old system when the frequency changed u lost the channels and manually had to find and enter codes.stuck on autoupdate loop,by putting on 400 [ genuine box only ] it seeks and finds info for u.

 

Ntl Ireland

 

sorry ryan were mixed up here i was talking bout the guy mcd82 doing a factory reset

 

could you tell me the steps

 

cactikid.That would be handy havin not to put in the codes. Where do I get firemware 4.00?

 

go to main menu press 1570,turn emu on.go and scan n*l and you should get all your channels.if you don't try the other providers.

 

you can get it at the link at the bottom of my post

 

http://www.drewish1.co.uk/

 

sorry yeah factory reset and turn emu on hope fully that will work

 

go back a page , I have the step be step guide there !!

 

automatic rescan still not working, help plz
Keeps saying failed beside it

 

factory reset.make sure you have the cable in the cable input.and try a scan.

 

is your EMU on m8 ?

 

so3bfof9
where do u have ur aerial lead going into [ cable input ] hopefully. when u do a scan do u select ur provider, then auto scan
channels found ?? has ur box worked in same place or just bought ?
no signal on screen do u have mmds [check n*l bill ]

 

Cheers. I'll try that tomorrow. Thanks

 

do a factory reset again then follow the steps in the help guide on the drewish link

 

yeah EMU on, still saying same no programs found

 

have you let it scan all the way, it says failed on a lot of the transponders dont mind this let it scan until its finished