New Eurovox TX For MMDS

This is a help forum and not fleabay.

 

scouser could u get me the frequencies for the box in ireland as when i put one in igot some channels so if i got the list could manually put them and get all the channels

 

.sorry scouser it is on n*t mmds i trying to get it work on

 

Is it for Dublin?

 

no for waterford

 

You do know the Eurovox TX is only for Ch**us MMDS and will not work on N** MMDS.

 

ya i know so im using the box instead thats why i want to manully put in the frequencies . i had the tx but no go but when i put the box in it work like when i put freq 375.00 i got 12 channels on it can u help mate

 

I can but why has an autoscan using N** with symbol rate 6887 not worked?

 

would that work if i tried that . could u send me channel freq too so that i have everything . i dont know much about the mmds . as i m on the cable myself just trying to help one of my friends

 

You dont need the frequencies, all you need to do is go to menu, installation, make sure N** is selected as provider and press autoscan, thats it

 

cheers mate u are a legend . i try that tonight i say i had it scanned in my house through the cable and it got all the channels but when i went to his house they didnt work. is that because when they scanned off the cable would be different to scanning off mmds

 

Exactly As you have scanned it on your cable set up, I would advise you to do a factory reset before putting it onto his MMDS set up.

 

Hi There Folks, I have just received a EuroVox TX DVB and tried to load some software to it. E_Vox_TX C____S Ireland MMDS. It appeared to to be sucessfull. However thereafter when I repowered it I got the following. boot, F_00, UA_C, CHdl. at this point it appears frozen and the remote does not have any effect. Can you point me in the right direction? Prior to this I was receiving the standard channels through the box. Rgds

 

my TX and a few others went off last night for a few minutes, they turned off then re booted and numbers came up od led. does anyone know if that was a code change and box updating

 

Does anybody know if two of these boxes can be used off the one aerial? Or can it be used with a proper Ch*rus box off the same aerial?

 

yeah i have two working

 

Darst,
I presume you have 2 power supplies.Just curious then why you see 2 MMDS aerials on the 1 house.

 

Why do you think its not possible to split the cable between power inserter and TV via an splitter or distribution amp?

 

I don't know.That is why I am asking the questions.Is it possible to split it as you suggest?

 

Why not. You will lose around 3db signal strength with a 2way splitter and depending on the signal strength a distribution amp is maybe the better option. The distribution amp has to support the full range without a gap between 230 mhz and 470 mhz.