1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Power Calibration Area Error

Discussion in 'DVDR' started by jeditig, Dec 28, 2003.

  1. jeditig

    jeditig Member

    Joined:
    Sep 22, 2003
    Messages:
    17
    Likes Received:
    0
    Trophy Points:
    11
    I have pinnacle Instant CD DVD. I am trying to put some mpegs onto a DVD. I have an aomagic generic DVD-R burner. The programs reads the blank DVD media, but when it goes to write, it brings up the Power Calibration Error. I have seen posts about ASPI, which I did but I have all IDE devices. I read another post about maybe not enough power to the drive.

    PLEASE HELP.

    PS, I previously had a Pioneer A05 that stopped reading DVD /CD, but would recognize the DVD-r, CD-R, it would not burn. I thought the drive went bad so i bought another. Any suggestions??

    Thanks
     
    jeditig, Dec 28, 2003
    #1
  2. wardair

    wardair Member

    Joined:
    Oct 24, 2003
    Messages:
    32
    Likes Received:
    0
    Trophy Points:
    16
    i have a power calibration error on my yamaha f1 cd burner and have no clue as to what causes it so i took out the drive
    good luck
     
    wardair, Dec 30, 2003
    #2

Share This Page