1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Problem with Freecom 32x8x4 CD Writer/Easy CD

Discussion in 'CD-R' started by hammerfan, May 12, 2003.

  1. hammerfan

    hammerfan Member

    May 1, 2003
    Likes Received:
    Trophy Points:
    I had a major problem with my pc, and as a result had to do a complete re-install.

    After loading the ghost software I went through the process of installing my over software, but for some reason I am having trouble reading CD's.

    Does anyone know what my problem is?

    Also, I managed to get Direct CD installed, and almost completed EZCD4 when my pc crashed. I rebooted to find that it had installed EZ CD, but there was no record of it in the START menu, or in ADD/REMOVE.

    This means I cant remove it.

    I am getting the problems of it not recognising there is a cd in the drive.

    Does the cd not get recognised if its very warm?

    Shall I retry reinstalling EZ CD, or do I be drastic and go for a full restore again.

    Your advice is greatly appreciated.
  2. Shoey

    Shoey Guest

    Easy CD Cre(a)mater can cause serious problems with your pc. DirectCD is "most likely" causing the conflicts. EZCD 4.0 is outdated and I recommend you unstall and try a freebie called BurnAtOnce. As far as packet writing software, I don't use as cdrw's tend to lock up my pc m8.
    Also after uninstalling run scan disc then reboot and install BurnAtOnce.

    Shoey :)_X_X_X_X_X_[small]Certified Computer Technician
    Forum Rules
    Mobo: KT4VL MSI-6712
    CPU: AthlonXP Barton 2.5
    Ram: 512 SD-DDR333
    HD: Maxtor ATA\133 80gi[/small]
    Last edited by a moderator: May 13, 2003

Share This Page