1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Serious problem (HELP)

Discussion in 'Xbox - General discussion' started by Optiskill, Mar 18, 2004.

  1. Optiskill

    Optiskill Member

    Joined:
    Jan 21, 2004
    Messages:
    13
    Likes Received:
    0
    Trophy Points:
    11
    i turned on my xbox today and it trys to boot up 3 times and then on the fourth try it frags, i get no video either could it be my video cable?
    i hope so it flashes red and green when it finally fires up
     
  2. Daskins

    Daskins Regular member

    Joined:
    Dec 23, 2003
    Messages:
    644
    Likes Received:
    0
    Trophy Points:
    26
    what chip do u have?
     
  3. Optiskill

    Optiskill Member

    Joined:
    Jan 21, 2004
    Messages:
    13
    Likes Received:
    0
    Trophy Points:
    11
    its a xecuter lite with the d0 point soldered and a 120 gig hdive had it workin for like 3 weeks but tonight it decided to pack it in
     
  4. Billyfett

    Billyfett Regular member

    Joined:
    Aug 21, 2003
    Messages:
    191
    Likes Received:
    0
    Trophy Points:
    26
    I habe had the same problem I doubled checked my chips connection and problem sloved.
     
  5. Daskins

    Daskins Regular member

    Joined:
    Dec 23, 2003
    Messages:
    644
    Likes Received:
    0
    Trophy Points:
    26
    yeah just check to see if any of the wires came out and check that they have a good connection and you should find your problem.
     
  6. Sukodin

    Sukodin Member

    Joined:
    Jan 28, 2004
    Messages:
    28
    Likes Received:
    0
    Trophy Points:
    11
    I agree with Daskins.. It sounds like your D0 point is not connected correctly.. I had a buddy of mine with the same chip that messed up the D0 point on the board, and it showed connected when he tested it (LED worked properly) however when he went to start it, it acted just how you describe.. We were able to buy some conductive paint and rebuild the D0 point and it works fine now..

    Hope that helps..
     

Share This Page