1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Shrinking Speed.

Discussion in 'DVD2One forum' started by fcoba85, Nov 22, 2005.

  1. fcoba85

    fcoba85 Member

    Joined:
    Nov 14, 2005
    Messages:
    20
    Likes Received:
    0
    Trophy Points:
    11
    My question is: What determines the shrinking speed? The Processor? The RAM? Hard Drive? WHAT?

    I'm currently working with two PC's. The First one is a 2.4 INTEL P4 400MHZ FSB, 512 PC2700 DDR RAM, 200 GB 7200 RPM Maxtor HD.

    The Other is a AMD Athlon 3200+ Socket 754 2.0 GHZ 1600 FSB, 2 GB's Of PC3200, Western Digital 250 7200 RPM HD.

    The P4 PC with DVD 2 One Shrinks on average at 25-28 Minutes.
    The AMD PC shrinks at about 15 Minutes.

    What determines shrinking speed????
     
  2. WACKMASTA

    WACKMASTA Member

    Joined:
    Nov 21, 2005
    Messages:
    16
    Likes Received:
    0
    Trophy Points:
    11
    all of the above.amd is better at video/gaming files also.
     
  3. ireland

    ireland Active member

    Joined:
    Nov 28, 2002
    Messages:
    3,451
    Likes Received:
    15
    Trophy Points:
    68
    From Microsoft:
    "Basically, DMA or Direct Memory Access is a system that allows devices in your computer to transfer data directly to and from RAM without having to use the CPU as an intermediary. This boosts the performance of your PC significantly as not only the device from which the data is being read responds quickly, but also leaves the most important component, the CPU, free for other critical operations. However, the UDMA or the Ultra direct memory access is further advancement over the DMA technology that uses even higher data transfer rate thereby boosting the overall performance of the PC.
    For repeated DMA errors. Windows XP will turn off DMA mode for a device after encountering certain errors during data transfer operations. If more that six DMA transfer timeouts occur, Windows will turn off DMA and use only PIO mode on that device.
    In this case, the user cannot turn on DMA for this device. The only option for the user who wants to enable DMA mode is to uninstall and reinstall the device.
    Windows XP downgrades the Ultra DMA transfer mode after receiving more than six CRC errors. Whenever possible, the operating system will step down one UDMA mode at a time (from UDMA mode 4 to UDMA mode 3, and so on).


    If the mini-IDE driver for the device does not support stepping down transfer modes, or if the device is running UDMA mode 0, Windows XP will step down to PIO mode after encountering six or more CRC errors. In this case, a system reboot should restore the original DMA mode settings.
    All CRC and timeout errors are logged in the system event log. These types of errors could be caused by improper mounting or improper cabling (for example, 40-pin instead of 80-pin cable). Or such errors could indicate imminent hardware failure, for example, in a hard drive or chipset.

    GO HERE TO THE WEB SITE AND FOLLOW DIRECTIONS AND SEE THR PRETTY PICTURES.
    http://www.dvdplusvideo.com/dvdguide005.html


    Sometimes the DMA/PIO mode "sticks" and won't change when you try to select DMA.
    You can delete the secondary channel IDE controller from Control Panel. Then reboot your system and the system will reinstall the controller when you reboot. This often fixes this problem.


     
    Last edited: Nov 24, 2005

Share This Page