Starview and EuroVox Man V

it was disabled, i put them both to enabked, when doing the kuro download it involves doing a factory reset, does the effect any other settings?

 

do not use the emm capture enabled this needs to be disabled all the time only emulation is enabled

Make sure you have taken your channel data off before you flash the box ok otherwise it might not find your transponders

 

ok grand i put emm capture back to disabled, could it be the tv settings in configuration?

 

it could be that you did not save your channel file so it cant find them now did you take a channel file off your box before you flashed the new image

 

in system information it says:

Model DVB-XC BOX V TDA
S/W ver 1.0 STC4 apr 19 2008
H/W ver 2.0t.K5
Bootstrap v001
S/W build Kuro

If that is any help???

 

no i didn't get channel file before i flashed, can i get one from somewhere?

 

yep you have the correct firmware on your box only problem is that you flashed the box before taking the channels off

So now if your box is not picking up the channels there is a few things you can do

if you live in Ireland and are on N** there is a channel dump in the eko site with scOusers name on it

If you live in uk you will prob have to reflash to older firmware and rescan then take the channel file off and then reflash with the new firmware and then put the channel file back on again

 

ok i live in dublin, so i will try upload scouser.cdf now

 

still sayin no signal, the cdf file downloaded i have all the channels names and numbers but no signal?????

 

check your cable so and make sure there is not a breakdown in it ok

 

ok checking on main cable input

 

SUCCESS!!! Thank YOU very very much. thats why this site is so great! Thanks a million!!!!!!