starview No channels found

yes its brand new and its the exact same as the other box.
the Box 3 Super

 

Check what provider id comes up on your friends box and make sure you are scanning the same one.

 

yep checked all that. using exact same provider id and codes

 

raiden, try this
Menu > factory setting
pin > 0000 ok to Delete
Turn off the b0x at the back for a min & turn back on
Disconnect from TV, put it in standby & flash it with the 7.09 beta
Connect to TV
Choose english > installation, select provider
autoscan > press ok
channels found
Exit
Menu > 1570
Turn emu on, Exit Exit Exit

 

ok ill try the beta firmware. Thanks

 

ok ill try the beta firmware. Thanks

 

i was having similar problem so i followed the instructions but
still cant get all channels, comes up on screen as data is being updated but % doesnt go up :-(

 

lazy update switch to another scrambled channel and wait 10secs should move .or power off box then on works also.

 

all good now thanks

 

thanks a mil for all your help. its working now with the 7.09 firmware.
much appreciated and kudos to all

 

hang on spoke too soon. i can get every channel except rte1, rte2 and tv3. any suggestions

 

oops never mind. got those in. just took note of their frequency from the other box and used manual scan to pick them up.
thanks for the help

 

i would say previous firmware was faulty when no channels found and you kept at it and did not throw it out window lol.good to hear all sorted.

 

Well Done on getting it sorted

 

having the same prob discussed in this thread...tried everything said but with no luck.im going to move it to the main cable into the house, would that make a difference?

 

so it did make a difference, but once i move it back to the secondary cable i can get all the channels...any ideas anyone?

 

if the problem was no channels found on secondary line must be bad connection or cable,as it works with main supply u must be getting a stronger signal.