Starview - The Box - No signal? Cannot scan any channels

I moved sr The Box from one room to the bedroom and now have no channels . I input the corrects codes after a scan i still have no channels. Help much appreciated

 

Put the box back into the room you had it working , you dont need to rescan when putting into a different tv

 

I did that but it didnt work now it finds the channels during the scan but when i view them they come up as bad channel or scrambled.

 

check is your EMU on. go to menu press 1570 and turn EMU then exit

 

Hi, All,

If anyone has "THE BOX", please leave it plugged into the MAINS at all times, never switch it off, when not using it, just put it in STANDBY MODE.

 

Mine was unplugged from the mains and now i have no channels at all even thought the channels are located when i go to view them they are bad channels.My boyfriend reset the factorty settings could this be the problem? EMU is on Dave nojoy!

 

I will send you a PM (this should help).

 

What is your location and what incoming cable are you using

 

Its working again cheers can i not move it to another location if i unplug it will it stop working again

 

i would like to know that my self. maybe cityfan has the answer

 

It should work in another room , you do not need to rescan for channels as they will be there , Just make sure you have your incoming cable and scart lead in properly.

 

Hi,Ya,

Today ,just to try it out, ok. I moved THE BOX upstairs to the bedroom, whereby i have the ordinary cable N*L, basic package. Then connected my box to it, i went back to factory settings and started all over again. EVERYTHING WORKED JUST LIKE DOWN STAIRS.........

Hope this is of help to you.......... I used a scart lead..

 

Hi Guys have a little problem with 2 channels E4 and SKY Drama both channels have blured pictures sound is ok.Its like they need a little fine tuning but i dont know how to do this

 

have a look in your channels and see do you have extra ones they could be them doubled and if so and you can here and see the delete the other ones ok

 

try a manual scan
menu , installation, manual scan, downfrequency.
channels should come in again so you will prob have duplicates of certain ones.
just delete the bad channels

 

lookin good cityfan!
should be the red side though lol !!

 

Thanks for our reply . Tried the manual scan but still the same problem

 

Ok the only other solution is to check ur cables and scarts are in correctly
other than that i would personally do a full autoscan..
if that dont work 'a factory reset' and autoscan again.....