STARVIEW UPDATING FIRMWARE - NO CODE BEGGING HERE

ok different provider?have u scanned over there and changed it
and where are u plugging u r coaxial in??? hahahahahahah

 

No same provider, different provider tried,scanned about 10 times... No channels found message ,Factory settings, default, emu, every trick that I know of and nothing!

 

try house each side if possible,if it works in either his house is f****d

 

Due to certain occupations going next door wouldnt really be an opption LOL

 

did u ever try the stink bomb trick lol

 

Still stuck!! Wheres Noel& Karl, Sc0user, Celtic when I need them LOL

 

Got to be a signal problem surley, take out any splitters check connections, If his box works fine at your house and doesnt at his own and providers same what else could it be? do you have a booster you could try also does there subbed box work? if not CC problem?

I got to go out sure the pro's will be along shortly. best of luck with it.

 

He has full signal for the normal channels ,has had a box for well over a year,no problems,Just a strange one..... have been waiting for the EXPERTS since 6pm even PM,d a couple so much for solidarity LOL, another few minutes and I am off to a barstool LOL

 

have you done a factory reset des and tryed scanning again?

 

Karl, I think i have tried everything that I know, Been at it since 2pm, I think its so strange that I can pick up about 5 stations including disney that are numbered channels as opposed to named ones if you understand, its a pain in the ...... another couple of suggestions then off to the boozer!

 

dont even think the main men & women could give you an answer des,might be a good idea to have a few gargles and try again tomorrow

 

Might even try it after the battle cruiser LOL
might do something that makes it work LOL

 

bring it with you jaysus what about the dubs!

 

Try reflashing it , then factory setting , then auto scan Des.

What SV is it and what version is on the b0x ?

 

Des, i flashed a sv3 a few weeks ago with the 7.09 & was missing a few channels, also the channels were numbers like your neighbours.
I reflashed it with the 8.00, did a factory reset & autoscan & everythings back to normal. Dont know if this is any use (probably not lol).

 

des it sounds like a signal prob not been strong enough how old is the feed and change the cabling and see if that does it

 

Hi, I've been trying to get my genuine Starview Box 3 Super to upload the firmware for hours with no success.

Have GTromloader 8.00. Also tried older versions.

I tried connecting my computer to the box with the serial cable (have the exact one from Maplin) but didn't work.

Also tried connecting a usb adapter to my laptop but no go. I checked port & selected correct one. USB device is installed on computer with little cd it came with.

Racking my brains here. Any ideas?

 

Have you got the b0x on standby when flashing it, & is it disconnected from the TV??

 

Not connected to tv.

Yep, when I plug it in it says On, then I press power button at front, so it shows the time 12:00. Assume that it's now on Standby.

 

ok, and its definitely a null modem cable DB9F to DB9F that you`re using?