1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

trying to update to V4.

Discussion in 'Digital TV - UK & Europe' started by goz83, Jul 23, 2007.

  1. goz83

    goz83 Member

    Jul 18, 2007
    Likes Received:
    Trophy Points:
    I have the null modem and adaptor cables and downloaded the software onto my laptop. the hardware is hooked up and recognised. I switched my comp and box off and on but nothing is happening. its as if the comp and box are not connected. any suggestions?
  2. Celtic71

    Celtic71 Active member

    Jul 3, 2007
    Likes Received:
    Trophy Points:
    Updating Firmware

    Connect your box and PC with a Null modem cable and switch on the cable box and put it on STANDBY.
    (The Starview does not need to be connected to TV to update it with GTROM)

    Open GTROM Loader software make sure that you set the correct COM PORT
    that matches the one that is being used

    Make sure App file only is selected, then click Bin File & browse to the firmware where you downloaded
    it to on your PC.

    Run the GTROM loader by pressing Download and you will see the % progress increase
    then Download completed message on your PC.
    Wait until you see the DOWNLOAD COMPLETE pop up on your PC before
    removing the NULL MODEM CABLE. The Starview will then reboot

    Turn off and pulg your tv cable and scart back in

Share This Page