i have the x-ecuter 2.2 lite. after installation it asked me to update the bios. updated it with cromwell 1.6a. now when the chip is enabled it turns on and off 3 times ending with the eject button flashing green and red. can some one tell me what the problem is?
is it connected to your pc (ie network) if so unlpug it then try again, switch it off , not reset, then back on
Mine is doing that too now. I'm using an xecuter 2.3 lite PLUS and it starts up, blinks green 3 times every few seconds, then ends w/ the red/green/red/green or sometimes just stays yellow...how do I fix this? Should i continue to scrape the DO point to open it up, or what is wrong!?
