this is supose to be the correct my gc is like this is there another places that i can soldering? any ideas? the gc works fine now, but i have the xeno and im thinking a alternative way to install it.. full picture of my gc http://www.brimg.com/uploads/8/e4e0c08251.jpg ow the gc is like this now because the last owner must have ripped of his xeno ;/ is there is no hope i will end up buyng the qoob sx and install it ;/
ouch! the soldering pads are completely removed.... Yeah you will need an alternative method for sure!..or another cube. luckily the Viper and Qoob both install to the main board, just remember Qoob has 2 wires to solder to IC Pins as Viper has only one so if your new to soldering Viper might be easier as IC pins are a pain to get soldered and not cross. Good luck!
