1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

XLCD

Discussion in 'Xbox - Hardware boot discussion' started by wr6739, Jan 7, 2006.

Thread Status:
Not open for further replies.
  1. wr6739

    wr6739 Regular member

    Joined:
    Jun 1, 2005
    Messages:
    406
    Likes Received:
    0
    Trophy Points:
    26
    I have installed the control panel that goes along with the Xecuter 3, and it all works fine except for the LCD, it just stays blank and won't turn on. I connected the cable from the LCD to the chip and enabled it in the bios, and tried adjusting the contrast dial, but still no luck. Any ideas/suggestions. Thanks
     
Thread Status:
Not open for further replies.

Share This Page