UPC replacing boxes in dublin.

thanks so much.....

 

DesB,
Can you take another look when you get a minute. http://forums.afterdawn.com/thread_view.cfm/2/677561#4258099 under funkyfive 9th sept 15.58 cheers

 

John, you have a starview....

Ok make sure the little white cable is fully pushed into the connection cable input...when you press menu can you press 1570 or are you stuck on the language page?

 

heres a tutorial compliments of celt71:

To see which port your USB adapter is connected to, connect your USB adapter and follow the following instructions:

1. Go to the Start Menu
2. Right click on "My Computer"
3. Select "Properties"
4. Click on the "Hardware" tab
5. Click on "Device Manager"
6. Click the + sign next to "Ports (COM & LPT)"
7. One of the listed ports should indicate which port your USB adapter is connected to (e.g. COM1, COM2, COM3, etc.)
8. Go back to your map software program that you use to transfer data and make sure it is looking at the correct port.
9. You should be able to transfer data once the correct port is selected

If you need drivers go here

http://www.gilsson.com/usb_drivers_download.htm

Follow my advice to step 7. Locate your USB Adapter (port *)

Right click on that port and select properties. Then select port settings, then select advanced. At the bottom of that tab will be a drop down box with the port selected (port * in your case). Use the drop down to select another port (eg 1, 2 or 3). If the port you want to use is already allocated to something else, you can use the same procedure to reassign that port after you have finished.
Save the selections in the usual way. The USB converter will be permanently assigned to the port you selected.

 

des , i have had starviews for over a year now even flash the box, it just aint working anymore, do i need to flasch my boxes again with new firmware, i have a problem wuth my usb to rs232 connection though

 

John i will be heading shortly so can you tell me please when you press menu can you press 1570 or are you stuck on the language page?

 

DesB,
I had already took time to look back at this and tried it but added in your bit at the end but still no joy.Com 1 is the one I selected as it showed up com2 and 3 were in use.

 

sorry, i turn on the box and do a factory reset (as the box was working previously) whin i do 1570 it just takes me into nagravision menu. I do an insatllation and it finds no cahnnels. I am saying n*l changed my system wit new box and ever since then starviews were gone

 

ok one more shot then i am off to the pit!

press menu 1570 press default turn on emu,exit go to sly spots and it should say updating data... if not we can try again tomorrow!!

 

thanks for your help des i'm off now too any suggestion please let me know i'll check them tomorrow